Infiniti QX60 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
139 Posts
Discussion Starter #1
Issue with my rear window(the rear most window with the fancy curve) rubber molding/gasketing - looks like it caved in.
No support behind it if I gently press it.
I checked the opposite side rear most window molding and it's looks and feels fine - no give in the molding.

Anyhow, took it to dealer and they've never seen that before. They said they'll replace it under warranty, but they need to order the entire rear glass assembly with the chrome trim and rubber molding/gasketing. :eek:

Most likely some assembly issue at plant - disappointing quality control...
 

Attachments

·
Super Moderator
Joined
·
563 Posts
I have a gasket that surrounds the rear stainless steel bumper protector ready to fall apart. I've noticed a few flaws with some of the vehicle trim and will have the dealership repair them when it goes in for the right front airbag recall. There really isn't an excuse for poor quality moldings on a luxury vehicle.
 

·
Premium Member
Joined
·
539 Posts
I've seen some problems with the earlier (JX) SS bumper protector trim that Bob describes, but the dgandbver problem I've never seen before. Seems like a one-off problem and I'm sure warranty will cover it.
 
1 - 3 of 3 Posts
Top